MINILAB Dehydrator


For Waveguide Transmission Line

Max. Flow rate: 1 CFM (150 l/h)

Output Pressure: Factory set at 0.3 psig (2 kPa), on request 0.15 – 0.9 psig (1 – 6 kPa)

The MINILAB dehydrator achieves reduced mechanical wear and noise, and therefore, a long lifetime through its adaptive flowrate feature, dual compressors and drying chambers, and the fact that there are no moving mechanical parts in the system. Pump speed control avoids mechanical pressure regulators, thus eliminating undesirable pressure losses and a worse response to plant air flow regulation.

MINILAB Dehydrator brochure


The Kintronic Labs MINILAB dehydrator is set apart from the rest of the pack as a result of

LAB Series Technology

  1. They are completely service free
  2. Pump duty is limited to a minimum – electronic control of the pump by Pulse Width Modulation (PWM) supplies a real time flow rate equivalent to the real time leakage rate
  3. No mechanical parts in movement, thus lowering wear; no solenoid valves (they limit reliability of the system)
  4. No pressure regulator is needed – the target pressure is automatically held in the unit being pressurized
  5. There are two pumps working alternatively (50% of the time each), and they’re driven to operate below their maximum flow rate, further increasing lifetime of the dehydrator


  1. Includes two pumps and two drying chambers running alternatively to yield an MTBF of > 165,000 hours
  2. Drying chambers with automatic regeneration
  3. Optional remote monitoring interface via SNMP protocol and HTTP interface by a 10/100 MB Ethernet interface
  4. All local and remote alarms controlled by SPDT Relay
  5. Low power consumption and low acoustic noise


There are no reviews yet.

Be the first to review “MINILAB Dehydrator”